DCIS 2023: 38TH CONFERENCE ON DESIGN OF CIRCUITS AND INTEGRATED SYSTEMS
PROGRAM

Days: Wednesday, November 15th Thursday, November 16th Friday, November 17th

Wednesday, November 15th

View this program: with abstractssession overviewtalk overview

09:20-10:20 Session 2: IEEE CAS Distinguished Lecturer

IEEE CAS Distinguished Lecturer: Sudipto Chakraborty

Title: Ultra-low Power Cryo-CMOS Designs for Next-Generation Quantum Computing

This talk will cover practical challenges for cryogenic CMOS designs for next generation quantum computing. Starting from system level, it will detail the design considerations for a non-multiplexed, semi-autonomous, transmon qubit state controller (QSC) implemented in 14nm CMOS FinFET technology. The QSC includes an augmented general-purpose digital processor that supports waveform generation and phase rotation operations combined with a low power current-mode single sideband upconversion I/Q mixer-based RF arbitrary waveform generator (AWG). Implemented in 14nm CMOS FinFET technology, the QSC generates control signals in its target 4.5GHz to 5.5 GHz frequency range, achieving an SFDR > 50dB for a signal bandwidth of 500MHz. With the controller operating in the 4K stage of a cryostat and connected to a transmon qubit in the cryostat’s millikelvin stage, measured transmon T1 and T2 coherence times were 75.7μs and 73μs, respectively, in each case comparable to results achieved using conventional room temperature controls. In further tests with transmons, a qubit-limited error rate of 7.76x10-4 per Clifford gate is achieved, again comparable to results achieved using room temperature controls. The QSC’s maximum RF output power is -18 dBm, and power dissipation per qubit under active control is 23mW.

Location: Room A
10:30-11:30 Session 3A: S1A Radiofrequency circuit designs based on two-dimensional devices
Location: Room A
10:30
Design of GFET-based active modulators leveraging device performance reproducibility conditions (abstract)
10:50
Devices and circuits for HF applications based on 2D materials (abstract)
PRESENTER: Henri Happy
11:10
On the influence of technological parameters on the expected performance of GFET-based mixers. (abstract)
10:30-11:30 Session 3B: R1B Analog Circuits
Location: Room B
10:30
Experimental Demonstration of Associative Memory in Coupled Differential Oscillator Networks (abstract)
PRESENTER: Juan Núñez
10:50
Three-Stage Low Dropout Regulator with Enhanced Transient Response and Regulation Performance (abstract)
11:10
Super Class AB Amplifiers: A Unifying Approach (abstract)
10:30-11:30 Session 3C: R1C Energy Harvesting
Location: Room C
10:30
Design of SoC FPGA based controller to reduce shadow effects in photovoltaic installations (abstract)
10:50
Integrated Cuk Inverter for Single-Phase Grid-Tied Photovoltaic System (abstract)
PRESENTER: Leonardo Sampaio
11:30-12:10Coffee Break
11:30-12:10 Session 4: PhD Competition
SMART CORROSION MONITORING BASED ON NON-DESTRUCTIVE TESTINGS (NDTs) (abstract)
FPGA-based Acceleration of AI Structures for RIS Applications (abstract)
PRESENTER: Ruben Padial
Oceanographic Profiler for Long-Term Measurements of Energy and Tidal Currents (abstract)
Maximally Digital VCO-based ADCs with Programmable Pulse Shaping Filters (abstract)
Inertial-Instrument for Monitoring Offshore-Cage Mooring-Line Dynamics (abstract)
SpeedEdge – Acceleration microarchitectures for Edge applications (abstract)
PRESENTER: Gonzalo Salinas
Unleashing the Potential of 2D Material Devices in Nonlinear RF Circuits (abstract)
FPGA-Based Acceleration for Emerging Neuromorphic Computing Paradigms (abstract)
Real-time embedded eye detection and analysis framework (abstract)
Run-Time ML-Based Modeling and Management of Reconfigurable Multi-Accelerator Systems with Virtualization Support (abstract)
Time-encoded audio MEMS sensors optimized for edge computing (abstract)
PRESENTER: Michele Noviello
Configurable electrical stimulation system for cardiac tissue samples (abstract)
Towards highly efficient audio processing: New Analog-to-Digital and Analog-to-Information architectures for Edge devices (abstract)
12:10-13:30 Session 5A: S2A Digital Signal Processing modules and architectures for 5G and 6G mobile networks
Location: Room A
12:10
A 5.2-GS/s 8-Parallel 1024-Point MDC FFT (abstract)
PRESENTER: Pedro Paz
12:30
Any-Radix Efficient Parallel Implementation of the Fast Fourier Transform on FPGAs (abstract)
12:50
An Automatic Generator of Non-Power-of-Two SDF FFT Architectures for 5G and Beyond (abstract)
13:10
High-Throughput DTW accelerator with minimum area in AMD FPGA by HLS (abstract)
PRESENTER: Javier Hormigo
12:10-13:30 Session 5B: R2B New Computing Paradigms
Location: Room B
12:10
UML-Based Design Flow for Systems with Neural Networks (abstract)
PRESENTER: Hector Posadas
12:30
Analog/Mixed-Signal Standard Cell Based Approach for Automated Circuit Generation of Neural Network Accelerators (abstract)
PRESENTER: Roland Müller
12:50
Machine learning infrastructure for managing a electric vehicle fleet using a cyber-physical system framework (abstract)
13:10
Approximate arithmetic aware training for stochastic computing neural networks (abstract)
12:10-13:30 Session 5C: R2C Embedded Computing
Location: Room C
12:10
Automatic code generation from UML for data memory optimization in microcontrollers (abstract)
PRESENTER: Hector Posadas
12:30
Low-power EEGNet-based Brain-Computer Interface implemented on an Arduino Nano 33 Sense (abstract)
PRESENTER: Daniel Enériz
12:50
Evaluating the soft error sensitivity of LU decomposition on low-power and high-performance GPUs (abstract)
PRESENTER: Jose A. Belloch
13:10
Accelerators in Embedded Systems for Machine Learning: A RISCV View (abstract)
13:30-15:00Lunch Break
Thursday, November 16th

View this program: with abstractssession overviewtalk overview

09:30-10:30 Session 8: Keynote Session

Keynote presentation: Davide Schiavone

Title: X-HEEP: A RISC-V Open-Source, Configurable, and Extendible Platform for Heterogeneous Ultra-Low-Power Edge-Computing Devices

After introducing the state of the art of open-source hardware/software and its importance and impact for growing all together in an open/collaborative way, we will introduce the platform X-HEEP (eXtendable Heterogeneous Energy-Efficient Platform).

X-HEEP is an open-source, configurable, and extensible single-core RISC-V microcontroller developed at the Embedded Systems Laboratory (ESL) of EPFL for edge-computing heterogeneous platforms. It is built on top of existing, mature open-source IPs from the OpenHW Group, the PULP team from ETH Zurich and the University of Bologna, and the lowRISC OpenTitan project and extended with custom blocks and logic to provide a system that can be easily extended via the X-HEEP interface with different accelerators, ranging from near/in-memory computing blocks, multicore systems, CGRAs, etc.

In this talk, we will show how X-HEEP can be configured to meet a wide range of requirements, how it can be extended with accelerators, and how it is used as a research platform for fast prototyping. We will show the results of our first prototype in TSMC65LP, where we used X-HEEP next to our CGRA, showing how X-HEEP and its interface can be efficiently exploited to build energy-efficient heterogeneous platforms.

Location: Room A
10:30-11:30 Session 9A: S3A RISC-V and Open hardware: research, training and innovation towards Open-source Hw/Sw
Location: Room A
10:30
Simplifying RTL design and verification in chip manufacturing: A paradigm for Electronics Teaching using Open-Source tools (abstract)
10:50
PEAK: An Open-Source FPGA platform for Many-Core Architecture Exploration (abstract)
11:10
Sargantana: An Academic SoC RISC-V Processor in 22nm FDSOI Technology (abstract)
PRESENTER: Francesc Moll
10:30-11:30 Session 9B: R3B Analog Circuits
Location: Room B
10:30
A Two-Stage Amplifier in a Low Power 32.768kHz Quartz Crystal Oscillator (abstract)
PRESENTER: Marine Brun
10:50
Output Phase and Gain Error Reduction Design-Oriented Single-Ended to Differential LNA (abstract)
11:10
GBW Optimization in Two-Stage OTAs Operating in Weak Inversion (abstract)
10:30-11:30 Session 9C: R3C Sensor Circuits
Location: Room C
10:30
Design Space Analysis for a Digital Lock-In Amplifier for Infrarred Gas Sensor Signal Acquisition (abstract)
10:50
An ultra-low power custom IoT node for gas sensing applications (abstract)
11:10
Study of foveation mechanisms in Dynamic Vision Sensors (abstract)
11:30-12:15Coffee Break
12:15-13:15 Session 11B: R4B Analog Circuits
Location: Room B
12:15
Using Current to Drive Two SDC Memristors Connected in Series and in Anti-Series (abstract)
PRESENTER: Albert Cirera
12:35
CMOS Transistor Array for Cryogenic Temperature Characterization of MOS Components (abstract)
12:55
Ring Oscillator Circuits in Flexible aIGZO Technology for Biosignal Acquisition (abstract)
13:30-15:00Lunch Break
15:00-16:30 Session 12: Panel Session - From Labs to Market: Fostering Synergistic Collaboration between Academia and Industry

In recent years, the importance of microchips has become increasingly evident. Although one trillion microchips were produced in 2020, this year witnessed the largest chip shortage to date, resulting in a significant spike in the cost of electronic devices. As a result, numerous sectors have been impacted, not just the automotive industry.  The importance of increasing semiconductor production capacity cannot be overstated, as recognized by the EU Council's approval of the European Chips Act on July 25. As part of a wider effort to boost digital innovation in Europe, the European Chips Act seeks to increase chip production with the goal of regaining Europe's sovereignty. Similarly, the federal CHIPS and Science Act in the United States offers billions of dollars in incentives for semiconductor manufacturing.

In this context, numerous funding opportunities exist for both companies and research institutions. Could this environment be the ideal place to foster collaboration between industry and academia? Representatives from administration, industry, and academia will discuss this topic.

Location: Room A
Friday, November 17th

View this program: with abstractssession overviewtalk overview

09:00-10:20 Session 14A: R5A Programmable Devices
Location: Room A
09:00
Implementing a CNN in FPGA Programmable Logic for NILM Applications (abstract)
09:20
Flexible Deep-pipelined FPGA-based Accelerator for Spiking Neural Networks (abstract)
09:40
A Simple Power Analysis of an FPGA implementation of a polynomial multiplier for the NTRU cryptosystem (abstract)
10:00
A Security Comparison between AES-128 and AES-256 FPGA implementations against DPA attacks (abstract)
09:00-10:20 Session 14B: R5B Embedded Systems and SoC
Location: Room B
09:00
Timing requirements on multi-processing and reconfigurable embedded systems with multiple environments (abstract)
PRESENTER: Sara Alonso
09:20
Definition of a SoC Architecture for a High-Rate Correlator Bank (abstract)
PRESENTER: David Molto
09:40
Digital Spectroscopy Channel Integrated into a SoC for Testing and Analysis (abstract)
09:00-10:20 Session 14C: R5C Communications - Design of power aware circuits and systems
Location: Room C
09:00
Making Digital N-Path Mixers (abstract)
PRESENTER: Hasan Moussa
09:20
ADC Architectural Study for Digitally-Assisted Multi-Gigabit Data Communication Transceivers (abstract)
PRESENTER: Pedro Barba
09:40
SET and SEU Hardened Clock Gating Cell (abstract)
10:00
A Compact Double-Exponential Circuit for Single Event Transient (SET) Emulation (abstract)
PRESENTER: Sebastian Bota
10:20-11:00Coffee Break
10:20-12:00 Session 15: Poster session
FPGA Implementation of Sherman-Morrison Formula Using High-Level Synthesis and Graphical Blocks Programming (abstract)
Complexity Reduction of Baseband Volterra Modeling for Low Memory Cases (abstract)
PRESENTER: Stanislas Dubois
RTL Modeling of the RV32I Architecture with SystemC (abstract)
Maximum Operating Frequency Self-Tuning System on FPGAs Using Dynamic Reconfiguration (abstract)
Ciber-physical System Arquitecture for AUTOSAR Automotive Framework based on 5G communications (abstract)
Exploring Open-Source and Proprietary Design Tools to Implement a Symmetric Cipher on FPGAs (abstract)
Design and Evaluation of a RISC-V based SoC for Satellite on-board Networking (abstract)
PRESENTER: Armando Astarloa
Improvement of the estimation of execution cycles of Application SW for Cross-Compiled Simulation of RISC-V Platforms using AI (abstract)
PRESENTER: Eugenio Villar
Time-domain Architectures for Interfacing Phase Change Memory (abstract)
PRESENTER: Amadeo de Gracia
Experimental cartography generation methodology for Electromagnetic Fault Injection Attacks (abstract)
Exploration of Fast Sinewave Pattern Generation and Projection in a SoC-based System for Spatial Frequency Domain Imaging Applications (abstract)
PRESENTER: Pallab Sutradhar
QChain Node: an IoT based Mote for Remote Medicine Quality Monitoring (abstract)
12:00-13:00 Session 16A: R6A New Computing Paradigms
Location: Room A
12:00
Novel Iterative Hebbian Learning Rule for Oscillatory Associative Memory (abstract)
PRESENTER: Manuel Jiménez
12:20
Comparative Analysis of Neural Network Implementations for NILM Applications (abstract)
PRESENTER: Alvaro Hernandez
12:40
Stochastic Computing-based on-chip Training Circuitry for Reservoir Computing Systems (abstract)
12:00-13:00 Session 16B: R6B Embedded Systems and SoC
Location: Room B
12:00
SoC Architecture for Acquisition and Processing of the EMG Signal (abstract)
12:20
Time-Sensitive Networking to meet Hard-real Time Boundaries on Edge Intelligence Applications (abstract)
PRESENTER: Jesús Lázaro
12:40
SoC FPGA-based Multichannel Data Acquisition System with Linux-Baremetal AMP for Applications in the Field of Astrophysics (abstract)
13:30-15:00Lunch Break